Redsail Cutting Plotter User Manual download pdf (Page 2)

If you use vinyl roll, please before to cut unwind in advance the quantity of

material necessary for the cutting.

Place the pinch rolls about 1 inch inside on each side of vinyl, also lower the

intermediate pinch rolls.

To verify manually your vinyl alignment, place the cutter "OFF Line" (Red

Led) and use the top and bottom arrows to feed in and out vinyl from the

cutter.

To verify your vinyl alignment using the cutting control panel from

WinPCSIGN software, place the cutter "ON Line" (Green Led) click the feed

button, the cutter will unwind the necessary quantity of vinyl material for your

cut then will return in the point of departure the origin point (0,0).

Vinyl Cutter User Manual V5.0

Base assembly ...

E) 8 screws 1 ½” length.

F) 4 screws 5/8” length.

G) 8 screws 3/8” length.

A) 4 plastic dowels.

B) 4 plastic caps.

C) 6 cover nuts.

D) 6 nuts 1 1/4” length.

Use screws (E), fix the bases to the

sides bars.

Use C inside to fix the rolls bracket

Use the 8 screws shown in G to fix

the top braces.

Use a square or a

paper fix brackets at 90

degrees with the side

bars.

Place 2 dowels in sides, use screw

shown in F and fix to the horizontal

bar.

Arrange parts as show in

the picture.

Manual check of the

alignment:

Cutter “OffLine” Red led.

Use down arrow to feed out

vinyl material.

Use top arrow to feed in vinyl

material.

Before to cut:

1)Cutter in On Line (Green Led)

2)Click the alignment button to

check your alignment.

Remember always unwind manually the

necessary quantity of vinyl before

proceeding to the alignement test or

cutting.

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Redsail Cutting Plotter User Manual Page 2

Comments to this Manuals